Motion Control – Van Nuys, CA – The S-08-54 Series of Low-Profile Pull Type Clapper Solenoids from Magnetic Sensor Systems (MSS) are just 0.54 in (13.8mm). in diameter and 0.80 in (20.3mm). long and the overall extended length is 1.08 in (27.4mm).
Motion Control – Van Nuys, CA – The S-18-100 Series of Open Frame Pull Type Solenoids from Magnetic Sensor Systems (MSS) includes 18 different solenoids to select from based on the Voltage, Duty Cycle, Attractive Force (up to 100 oz) and Stroke requirements of the user. MSS Solenoid coils typically utilize 23 to 40 AWG (American Wire Gauge) windings with Class “F” insulation for better protection of the solenoid during longer duty cycles.
The S-18-100 Series solenoids are 1.000 in. wide x 0.84 in. high x 1.74 long and have a 1.00 stroke. The noncaptive plunger or actuator is 0.312 in. in diameter with a clevis end for load attachment.
Motion Control – Van Nuys, CA – A series of 1.250 in. diameter tubular solenoids has been released by Magnetic Sensor Systems (MSS). Ideal for strokes of up to 1.00 inch, the S-20-125 series of Pull Type Tubular Solenoids feature 18 different solenoids with 23 AWG to 40 AWG (American Wire Gauge) windings. This broad range of solenoids allows the user to select the best solenoid for an application based on the force, stroke length, voltage, and duty cycle requirements. If needed, MSS solenoids with higher temperature class coil and lead wire insulation can be specified.
Motion Control – Van Nuys, CA – Magnetic Sensor Systems (MSS) has released the S-63-38-H Series of Push Type Tubular Solenoids. These miniature 0.38 in. diameter solenoids can be used as a push type solenoid at the push end or a pull type solenoid at the pull end and features 16 standard off-the-shelf options to select from based on the Voltage, Duty Cycle, Force and Stroke requirement of the user.
Motion Control – Van Nuys, CA –A Series of Latching Pull-type Motion Control Solenoids released by Magnetic Sensor Systems (MSS) are low cost, economical to use, and easy to integrate into an application. The compact S-18-100T Pull-type Latching Solenoids are: 1.00 in. wide x 0.84 in. high x 1.73 in. long with 0.313 in diameter plunger.
